Broadband dual-polarized patch antennas fed by capacitively coupledfeed and slot-coupled feed

Designs of broadband dual-polarized patch antennas fed by promising feed structures of a capacitively coupled feed and a slot-coupled feed (antenna A), two capacitively coupled feeds of a 180° phase shift and a slot-coupled feed (antenna B), and two capacitively coupled feeds of a 180° phase shift and two slot-coupled feeds (antenna C) are proposed and experimentally studied. The first two feed designs are for the excitation of a single-element broadband patch antenna, while the last design is for a two-element broadband patch antenna. These proposed patch antennas have a thick air substrate, and the 10 dB return-loss impedance bandwidths obtained for the two polarizations are all greater than 13%. High isolation (<-30 dB for antenna A, <-32 dB for antenna B, <-35 dB for antenna C) between the two feeding ports for the entire impedance bandwidth of the proposed antennas can be obtained. Also, improved cross-polarization levels (>20 dB) in both E and H plane patterns for the two polarizations of antennas B and C are achieved     

Annular slot-coupled dielectric resonator antenna

An annular slot-coupled dielectric resonator antenna is investigated experimentally. As compared with the previous rectangular-slot version, the new configuration offers a much wider bandwidth of 18%. The return loss, radiation patterns, and antenna gain of the configuration have been measured and are discussed     

Microbiologic depuration of Anadara tuberculosa (Mollusca: Arcidae)

In Costa Rica the mollusk Anadara tuberculosa represents a risk for human health due to the contamination of the growing waters and the fact that its is consumed raw. The families depending on the income obtained through commercialization of these animals have a low education and economic status. Therefore, it is of great importance to develop and evaluate simple methods of depuration that could be easily used by these families to make these mollusks safe for consumption. Bottles containing 11 of saline solution (25g/l) were prepared in duplicates to test the bactericidal effect of acetic acid. The solution in each bottle was adjusted to ph 4.5, 5.0 or 5.5 or held at ph of 7.0 or 8.0 for the controls. The solution in each bottle was then inoculated with approximately 1 X 104 cfu/ml of coliforms. Counts of coliforms were determined for each bottle 0, 1, 2, 4 and 8 hours after inoculation. For the depuration studies, specimens with diameters ranging from 4.0 to 4.5 cm were collected from a harvester at the estuary of Puntarenas, Gulf of Nicoya. Fifty specimens each were depurated in separate tanks containing 25 1 of oxygenated saline solution adjusted with acetic acid to an initial ph of 4.5 (treatment) or non adjusted ph of 8.0 (control). Counts of Enterobacteriaceae were determined, in duplicates, every 12 hr for 48 hr. An additional fifty animals were depurated using the defined method and tested to determine if they met international standards of microbiological quality for aerobic plate count, Enterobacteriaceae count, Escherichia coli count and presence of Salmonella. A sensory evaluation using a triangle test was performed to compare a typical dish prepared with depurated or non-depurated animals. A significant coliform reduction was determined in a saline solution (25 g/l) at a pH range of 4.5 to 5.5. This reduction, during 8 hr, was higher in the acid treatments compared to the controls. During depuration, the elimination of Enterobacteriaceae bacteria was faster when acetic was used (initial ph = 4.5) than when it was not. This elimination was more important the first 24 hr, time defined as adequate for the application of the method. The method has the advantage of transforming the bivalve in a product that is safe for human consumption, since it guarantees that the international standards of microbiological quality, for raw and depurated mollusks, are reached. On the other hand, the sensory qualities of a typical dish prepared with depurated animals are not affected by the method, which can be easily implemented and applied by the people that work in the extraction of this mollusk.     

The advancing-front mesh generation method revisited

This paper presents a mesh generation method of the advancing-front type which is designed in such a way that the well-known difficulties of the classical advancing-front method are not present. The retained solution consists of using the first steps of a Voronoï–Delaunay method to construct a background mesh which is then used to govern the algorithm. The two-dimensional case is considered in detail and possible extensions to adaption problems and three dimensions are indicated.     

Tight bounds on Rician-type error probabilities and someapplications

Consider the classic problem of evaluating the probability that one Rician random variable exceeds another, possibly correlated, Rician random variable. This probability is given by Stein (1964) in terms of the Marcum's Q-function, which requires numerical integration on the computer for its evaluation. To facilitate application in many digital communication problems, we derive here tight upper and lower bounds on this probability. The bounds are motivated by a classic result in communication theory, namely, the error probability performance of binary orthogonal signaling over the Gaussian channel with unknown carrier phase. Various applications of the bounds are reported, including the evaluation of the bit error probabilities of MDPSK and MPSK with differential detection and generalized differential detection, respectively. The bounds prove to be tight in all cases. Further applications will be reported in the future     

Modification of the calcium and calmodulin sensitivity of the type I adenylyl cyclase by mutagenesis of its calmodulin binding domain

The type I adenylyl cyclase is directly stimulated by Ca2+ and calmodulin in vitro, and the enzyme is also stimulated by increases in intracellular Ca2+ in vivo. Ca2+ stimulation of the enzyme in vivo may be due to direct interactions of the enzyme with Ca2+ and calmodulin or to an indirect mechanism involving stimulation of the enzyme by Ca(2+)-activated protein kinases. In this study, we have made several point mutations within the calmodulin binding domain to determine if the Ca2+ sensitivity of the enzyme can be modified by mutagenesis. The catalytic activities of the mutant enzymes were comparable to wild type type I adenylyl cyclase. Substitution of Cys-507 with Ser-507 did not have significant effects on the calmodulin or Ca2+ sensitivity of the enzyme. However, replacement of Lys-504 with Asp caused a 4-fold decrease in sensitivity to Ca2+. Ca2+ and calmodulin stimulation were abolished by substitution of Phe-503 with Arg-503. Stimulation of type I adenylyl cyclase activity in vivo by intracellular Ca2+ was also greatly diminished with the Arg-503 mutant indicating that Ca2+ stimulation of the enzyme in vivo is due primarily to direct interactions with calmodulin and Ca2+. These data demonstrate that the Ca2+ sensitivity of this enzyme can be modulated by point mutagenesis within the putative calmodulin binding domain and indicate that the enzyme can be directly regulated by Ca2+ and calmodulin in vivo.     

Numerical simulation model of vibration responses of rectangular plates embedded with piezoelectric actuators

A numerical simulation model for random large amplitude vibration control of composite plate using piezoelectric material is presented. The H_∞ control design is employed to suppress the large amplitude vibrations of composites plates under random loading. The numerical simulation model is developed and based on the finite element method. The finite element governing equation includes fully coupled structural and electrical nodal degrees of freedom, and consider the von Karman large amplitude vibration. The modal reduction method using the structural modes is adopted to reduce the finite element equations into a set of modal equations with fewer degrees of freedom. The modal equations are then employed for controller design and time domain simulation. In the simulations without control, the value of the linear mode to the nonlinear deflection is quantified; and the minimum number of linear modes needed for accurate model is obtained. In the simulations with control, it is shown that the truncated modes, which are neglected in the control design, deteriorate the controller performance. Generally, the vibration reduction level is not monotonically increasing with the size of the piezoelectric actuator. The optimal piezoelectric actuator size depends on the excitation level. For higher excitation level, optimal actuator size is larger. The H_∞ controller based on the linear finite element formulation gives better vibration reduction for small amplitude vibration, but it still gives reasonable performance for large amplitude vibration provided that the piezoelectric actuator is big and powerful enough.     

A 150 MHz 0.6 μm BiCMOS superscalar microprocessor

An implementation of the Pentium microprocessor architecture in 0.6 μm BiCMOS technology is described. Power dissipation is reduced and performance is enhanced over the previous generation. Processor features, implementation technology, and circuit techniques are discussed. An internal clock rate of 150 MHz is achieved at 3.7 V and -55°C     

The effects of impact ionization on the operation of neighboringdevices and circuits

This paper examines the detrimental effects of excess majority carriers and photons induced by impact ionization on the operation of neighboring pn junctions, bipolar transistors, MOS transistors, and circuits. The experimental results show that in addition to an increase in the substrate surface potential due to the excess majority carriers, photons can lower the barrier of a pn junction and, as a consequence, shift the Gummel plot of an npn bipolar transistor. As for the neighboring circuits, an example in which the speed of an NMOS ring oscillator is retarded by impact ionization in a neighboring NMOS transistor is presented